Skip to main content

NUVO Panel SI (Snap-in) Ceilings

NUVO Panel SI (Snap-in)

  • Materials

    Aluminum Sheet: 3003-H14 alloy (Suitable for paint finishes), or 5005-H34 alloy (For use with anodized finishes). Minimum thickness 20 Ga. (.032” / 0.8 mm)

    Stainless Steel Sheet: Type 304 (Standard) or 316 (For higher degree of corrosion resistance). Minimum gauge 22 Ga. (.031” / 0.8 mm)

    Galvanized Steel Sheet: Electroplated galvanized, Minimum 24 Ga.(.028” / 0.7 mm)

  • Finishes

    Aluminum: Baked polyester powder enamel, or two or three coat fluoropolymer coatings by PPG® or Valspar®, or gray polyester prime for field painting. Also Class I or II anodic treatments

    Stainless Steel: Satin brush # 4, XL-Blend “S” Super-Satin Brush, Mirror # 8, Non-Directional Brush or Random Swirl.

    Galvanized Steel Sheet: Baked polyester powder enamel, or gray polyester prime for field painting.

  • Dimensions

    Nominal 2x2, 2x4, 2x6, 2x8 are standard sizes. Custom sizes available upon request.
    Please speak with your Nelson Representative to determine suitability of custom dimensions.

  • Acoustics

    Metal Ceilings are available both non-perforated (non-acoustic) and perforated (acoustic). Perforation patterns are limited only to the type of material and gauge chosen and available tooling. Presently Nelson offers more than fifty different perforation patterns ranging from diagonal, staggered to straight as well as round, square and oblong holes.

    Our standard acoustical material consists of a Black or Off-White pre-laminated fleece (SoundTex®) typically bonded to the concealed face of the ceiling panel.

    For more details and options see our booklet “Metalouges”- an introduction to architectural metals, or contact your local Nelson Sales Representative and request our Architectural Metals Binder.

  • Standard References

    A. ASTM E84 - Standard Method of Test for Surface Burning Characteristics of Building Materials and Assemblies.

    B. AAMA 605.2 - Specification for High Performance Finishes.

    C. ASTM A 366/A 366M Standard Specification for Commercial Steel (CS) Sheet, Carbon (0.15 Maximum Percent) Cold-Rolled; 1997.

    D. ASTM A 666 Standard Specification for Annealed or Cold-Worked Austenitic Stainless Steel Sheet, Strip, Plate, and Flat Bar; 2000.

    E. ASTM B36/B 36M Standard Specification for Brass Plate, Sheet, Strip, and Rolled Bar; 2006.

    F. ASTM B 209/B 209M - Standard Specification for Aluminum and Aluminum-Alloy Sheet and Plate; 2004.